Engineering calcpad excel6/13/2023 It will probably be 2021’s learning project. The free and open source nature of these languages is also very appealing, even for a common Windows user like me. I have been looking at Python and Julia lately, combined with Jupyter notebooks and some additional libraries (plotting, pdf export, LaTeX, data frames, mesh creation, FEM analysis, etc). It’s so easy to make a mistake and have it trickle down the design pipeline that sometimes I wake at night just to check if I haven’t made a mistake… That said, the lack of adequate proofreading in Excel is what bothers me the most. The unit handling capabilities of Mathcad were really never of any interest either (SI units user! ) Additionally, I have used VBA extensively for creating additional tools (moment-curvature analysis, laterally loaded piles, SAP2000 interfaces, etc) so I was never ready to really jump ship to any of those tools. I’ve had a look at them but it seemed like they could never replace Excel properly as there’s always a lot of simultaneous combinations to handle, so the spreadsheet format always seemed more natural to me. I have never used Mathcad or Smath professionally. Scientific and Engineering Unit Converter Duometrix is a set of two programs - an Excel Add-in and a Windows Standalone - that convert units for students, scientists and engineers. I’ve done it in Mathcad already but in comparison it seems easier to do in Mathematica. That said, if I had a problem that was very mathematically intricate, such as a spring-mass-damper system needing ODE’s I might prefer to start with Mathematica, given what I’ve seen in the demos and tutorials about setting up the problem. And in my case Smath doesn’t have the stability or product support for me to seriously rely on it for professional work with a variety of coworkers. In my case Maple and Mathematica don’t offer the simple clean output that looks like the algebra/calculus that I would prefer to put in a report, and insert loads of other code that isn’t relevant to the subject of the report. There are, of course, other capabilities and workflows in these other programs that have their uses. You won’t be able to just switch over everything you normally do into the other software without having to leave some of the functions you use behind. WebAssign can read a Microsoft Excel file only if it is saved as an Excel. If instead you normally write elaborate reports in Mathcad with things like formatted plots, tables, and program blocks, then you’ll have a much harder time. Microsoft Excel files can be saved in different versions of the file format. If you normally use Mathcad for simple isolated calculations, just for the sake of getting a clear answer, perhaps with units perhaps not, then you can probably transition to Maple or Mathematica rather easily. My experience is similar - Smath should probably not be trusted to calculations you will need to refer to years from now (the developer may move on to other things) and Maple is more of a mathematician/student’s tool than an engineering utility. I’ve given both Smath and Maple a try, too.
0 Comments
Leave a Reply. |